Locate the button
The button is located on the side of the PIR Motion Sensor.
Press and hold the button
- Make sure the battery is properly installed
- Press and hold the button
- Hold the button down for more than 5 seconds until the LED changes from increasing rapid blinking to slow blinking in white
Verify that the PIR Motion Sensor has reset
- Press the button briefly
The PIR Motion Sensor LED should be slowly pulsing in white indicating that it has been reset to factory settings. If it's not the case, go through the factory reset procedure again.
You can also reset your device by deleting it from the app: Deleting a device